RTX 8630 User Manual download pdf (Page 25)

Version 0.1 Page | 25

Site Survey Mode

To enable Site Survey Mode, do as following step:

STEP 1 On the Service Menu (or Debug mode) scroll down to the Site survey mode > Enable

the Site survey mode to switch from Off to On.

This sets the handset in a state to list all visible bases around it and/or chained to the same base

station(s). Handsets in site survey mode can display up to 5 other handsets with the strongest signal

strength.

In Site Survey Mode the handset MMI shows the RFP (including slave RFP) to which the handset is

locked to and the corresponding signal strength (RSSI).

Valid Inputs: On or Off

Line1: RPN 28 20 03

Line2: -dBm 56 84 78

Line3: FE PP: 1 FP: 4

Parameter/Line

Description

RPN

The line contains the list of base stations identified by the handset as RPNs of

the bases in respect to the signal strength values below. Up to 5 RPNs can be

displayed.

-dBm (Signal

Strength)

This indicates the actual signal strength information (RSSI) to the base station

the current handset is locked to and additional RFPs visible. RSSI unit is -dBm.

The RSSI value increases the closer the base is to the handset.

If the base could not be detected, the RSSI value will decrease and after a while

the entry will be deleted, if e.g. the dummy-bearer position has changed or the

RFP is unreachable.

FE PP:XX FP:XX

Indicates the number of sync/CRC errors (Frame-Errors) within the last update

cycle.

This information is only valid for the actual link to the relevant base station.

The PP value is the number of detected Sync/CRC error(s) within the last 100

receiving frames (per sec.). The FP value is the number of received bit

information within the last 100 receiving frames (per sec.). This information is

interpreted as Sync and CRC errors on the base station receiving side.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

No comments

RTX 8630 User Manual Page 25