Version 0.1 Page | 1 Handset Operations Manual RTX 8630
Version 0.1 Page | 10 Rear View - Handset 11. 3.5mm Headset connector 12. Volume Up key (side key) 13. Volume Down Key (side key) 14. Mute
Version 0.1 Page | 11 Tone Type and Volume Frequency definition A 440 Hz G 659 Hz M Hz S Hz B 622 Hz H Hz N Hz T Hz C 1109 Hz I Hz O Hz U Hz
Version 0.1 Page | 12 Handset volume Volumes for each tone are shown below. Tone Type Level Comment Ring Melody It depends on Ringer Volume S
Version 0.1 Page | 13 Display Handset LCD display 262K TFT type Color LCD with backlight. 176 x 220 pixel display For dial number: 1 2 3 4 5
Version 0.1 Page | 14 Handset LED One bi-color LED (Message light pipe) to provide three colour message indications (RED, GREEN, YELLOW). The
Version 0.1 Page | 15 4 Handset MMI - Operations The handset can be in three main states seen from the user: 1. Active call 2. Idle 3. M
Version 0.1 Page | 16 Outgoing Call by Pre-dial Simply pre-dial the phone number. It is also possible to select call an entry in the private
Version 0.1 Page | 17 Hold By pressing hold the call is on hold and can be retrieved or a second call can be established. From the second cal
Version 0.1 Page | 18 Conference Call Pressing Conference key makes it possible to add a thirds call and establish a conference call. Confer
Version 0.1 Page | 19 Hands free
Version 0.1 Page | 2 Contents Handset Operations Manual ...
Version 0.1 Page | 20 Change Ringer Type dis
Version 0.1 Page | 21 navigation key Up or Right. The volume can be decreased by pressing navigation key Down or Left. The currently used aler
Version 0.1 Page | 22 2. Any key: Pressing any key will answer an incoming call. The call is not answered by removing the handset from the c
Version 0.1 Page | 23 How to setup speed dial Prerequisite: There must be at least one contact in the contact list. Steps: 1. Go to the conta
Version 0.1 Page | 24 5 Handset - Service Menu Management This section describes how to use the feature
Version 0.1 Page | 25 Site Survey Mode To enable Site Survey Mode, do as following step: STEP 1 On the Service Menu (or Debug mode) scroll
Version 0.1 Page | 26 HS Logs The HS log is a debugging feature that allows the user to retrieve low level interesting messages from the hand
Version 0.1 Page | 27 Status This provides the present condition of the handset and the base station it is location registered to. Some of the
Version 0.1 Page | 28 Demo mode The demo mode enables constantly backlighting, so be aware of that when this mode is enabled backlight savin
Version 0.1 Page | 29 6 Calls Operations – Handset MMI Initiating Calls Enter Number Press Green Button to start dialing Originati
Version 0.1 Page | 3 Out of Range ...
Version 0.1 Page | 30 Call Holding Press the Hold option at the left while call session is in progress or
Version 0.1 Page | 31 Call Bridging (Attended Transfer) Enter
Version 0.1 Page | 32 7 Flow Graphs – Call Transfer Some Definitions – Call Transfer There are three actors in a given transfer event, each
Version 0.1 Page | 33 8 Flow Graphs – Conference Calls The intent of this document is to describe how to establish conference call sessions
Version 0.1 Page | 4 Call Conference (Conference) ...
Version 0.1 Page | 5 1 About This Document This document describes the features and functionalities available in the SME VoIP DECT Handset.
Version 0.1 Page | 6 2 Making Handset Ready In this chapter we briefly describe how to prepare the handset for use, install, insert and cha
Version 0.1 Page | 7 Damage Inspection: The following are the recommended procedure for you to use for inspection: 1. Examine all relevant co
Version 0.1 Page | 8 Open Back Cover 1. Press down the back cover lock and lift back cover away from the handset. 2. Remove Back Cover from
Version 0.1 Page | 9 3 Phone Overview Handset – Front View 1. Ear Speaker 2. Screen 3. Navigation Keys (Up/Down/Right/left) 4. Sele
Comments to this Manuals