SME VoIP System Guide, Version 1.9
Proprietary and Confidential
Chapter: SME VoIP Administration Interface
This is a radio network identity accessed by all Base units in a specific
multi-cell system. It composed of 5 octets. It is actually 5 different
variables combined together.
RFPI Format: XX XX XX XX XX (where XX are HEX values)
This feature is used for multi-location setups. Allows two or more
primary in the same system.
The two cells will be unsynchronized and handover will not be possible.
Auto create
multi
primary:
By enabled the system can generate cells in case a base goes into faulty
mode. Two cells will only be generated in case no radio connection
between the two cells is present. In order to recover the full system after
establish of the faulty base, the system must be rebooted.
Allow multi primary must be enabled for this feature to also be enabled.
Auto
configure
DECT sync
source tree
Enable this to allow the system to automatically synchronise the multi-
cell chain/tree.
NOTE: Must be enabled in order to allow a new primary recover in case
the original primary goes into faulty mode.
Allow multi primary must be enabled for this feature to also be enabled.
5.12.3 Base System Settings
Description of SIP Settings for Specific Base units is as follows:
Screenshot
Number of SIP
accounts
before
distributed
load
The maximum number of handsets or SIP end nodes that are permitted
to perform location registration on a specific Base unit before load is
distributed to other base units.
Note: A maximum of 8 simultaneous calls can be routed through each
Base unit in a multi-cell setup.
Permitted Input: Positive Integers (e.g. 6)
SIP Server
support for
multiple
registrations
per account
Enable this option so it is possible to use same extension (i.e. SIP
Account) on multiple phones (SIP end nodes). These phones will ring
simultaneously for all incoming calls. When a phone (from a SIP
account group) initiates a handover from Base X to Base Y, this phone
will de-register from Base X, and register to Base Y after a call.
Note: Choose Yes when the SIP server supports this feature otherwise
choose No for the Sip server does not support this feature.
Permitted Input: Yes, No
http://ArtTel.ru
Comments to this Manuals